Enter your search terms below:

Filters

Clear all

Topic

156 results found

Lost connection while setting up MX logger. Will it still start?

If you did not tap Start before the connection was lost, then the logger will not start logging. Connect to the logger again, finish choosing your settings, and then tap Start.

Read tech note

MX logger is listed in the wrong group. How can I change that?

  • Connect to the logger, tap Configure, and then tap Group.
  • Select a group for the logger or create a new group.
  • If you do not want the logger to be listed in any group, th
Read tech note

MX logger not appearing in the Recently Seen/In Range list on the HOBO screen

  • The logger may need new batteries.
Read tech note

Cell constant note

Because the U24 data logger uses a noncontact AC conductivity measurement system, the cell constant varies over the measurement range.

Read tech note

HOBOware heap error and aborting error work-around

HOBOware Java VM aborting message HOBOware 3.4+ (HOBOware 3.4.0 or higher only) HOBOware fix for “heap error, and aborting error.” This new command-line fix can make HOBOware work by modifying the shortcut for starting HOBOware.
Read tech note

RX3000 & U30 Networking, Firewall Problems

Network firewall difficulty: The network interface controller (NIC) in the HOBO RX3000 and U30-ETH and WIF will attempt to make a connection to the numerical IP address 208.85.146.151:54328 every "Readout Interval." Your firewall must allow the logger to connect to this IP address, and must also allow the MAC address of the logger NIC.
Read tech note

SMS text messaging

Sending SMS through mobile phones is easy. If you can be reminded through email, you can now be reminded through SMS.
Read tech note

U30/Hobolink account setup

Here is a quick rundown on setting up a U30: HOBOlink video
Read tech note

Unmap DTF files in Hoboware

Often this issue manifests itself when both Hoboware and BoxCar software are installed on the same computer. To correct the issue, simply unmap DTF file in Hoboware. (If you use a weather station, energy logger, or U30, you might not want to do this as the DTF extension will open in BoxCar.) In Hoboware go to: File / Preferences / File associations. Click "UnMap" on the DTF file type line.
Read tech note

HOBOware Performance for ZW Networks

HOBOware 3.0 Performance
Read tech note