Enter your search terms below:

Filters

Clear all

Applications

Resource Type

64 results found

How does a pulse recorder work?

A pulse recorder indicates the number of times an event occurred in a given time interval

Read tech note

Troubleshooting communication issues with USB data loggers, base stations, and shuttles

If you're experiencing communication issues with your USB data logger, base station, and shuttle, here are a few things to consider:

If using Windows -

Read tech note

UX Logger Firmware Update Troubleshooting

If you are having trouble updating the firmware on your UX logger, try these steps:

Read tech note

Build Your Own Thermistor

For instructions on how to build your own thermistor, please see attachment.

Read tech note

Voltage Divider for High Voltage Measurements

Please see attached.

Read tech note

Logging RH without Temp

The Bluetooth-enabled HOBO MX1101 and HOBO MX1102 loggers both use a Relative Humidity sensor that returns a temperature-compensated RH measurement.

Read tech note

How to configure differential pressure for bidirectional scaling

Set the PXU sensor to Bidirectional mode by moving the jumper to BI, as described in the attached manual.

Read tech note

Measure Direct Current with the HOBO RX3000 and the T-VER-H971 Transducer

To measure Direct Current using the HOBO RX3000 and the T-VER-H971 transducer, see attachment.

Read tech note

HOBO UX120-017: Dry contact, channel voltage.

When the switch is closed, low voltage (0V) is detected. When the switch is open, a 100K pull-up resistor brings the processor input pin to 3.3V.

Read tech note

HOBO MX110X buzzer decibel (dB) output

The buzzer decibel (dB) output of the HOBO MX1100 logger series is 65 dB to 75 dB, depending on battery level.

Read tech note