Image
Enter your search terms below:
1346 results found
MX logger is listed in the wrong group. How can I change that?
- Connect to the logger, tap Configure, and then tap Group.
- Select a group for the logger or create a new group.
- If you do not want the logger to be listed in any group, th
Read tech note
I can't connect to MX logger in the Recently Seen/In Range list
- Close HOBOmobile and then reopen it.
- Power cycle the mobile device and try connecting again.
Read tech note
MX logger not appearing in the Recently Seen/In Range list on the HOBO screen
- The logger may need new batteries.
Read tech note
Cell constant note
Because the U24 data logger uses a noncontact AC conductivity measurement system, the cell constant varies over the measurement range.
Read tech note
Judd Communications Snow Depth Sensor with the U30 Remote Monitoring Station
Check out the attached PDF to find out how to use the Judd Communications Snow-Depth Sensor with the HOBO® U30 Station.
Read tech note
Waterproof shuttle for beginners (Video)
http://www.youtube.com/watch?v=klICZjtoiLE
This 5-minute video will walk you through the steps to take when using a waterproof shuttle.
Read tech note
Stainless steel loggers and salt water
Following is an important application note regarding the deployment of the following products:
U20-001-01 – HOBO Water Level Logger
U12-015 – HOBO U12 Stainless Steel Temp Logger
U12-015-02 – HOBO U12 Stainless Steel Temp Logger with 5” probe
Read tech note
Deploying a logger in a culvert pipe
Here’s a link to a YouTube video showing the installation of our conductivity loggers in a culvert pipe:
http://www.youtube.com/watch?v=bpNwM6jQQWo&feature=plcp
Read tech note
T-VER-E50B2 operation
The T-VER-E50B2 Energy and Power Meter outputs three sets of pulses that are logged by the UX120-017. These pulses represent Watt-hours, Amp-hours, and VAR-hours. HOBOware software uses these pulse values to calculate AC Current, AC Voltage, kW, Power Factor, VARs, and VA.
/files/14993-A-Derived-Channels.zip
Read tech note