Image
Enter your search terms below:
1348 results found
Adding or Removing Smart Sensors from a HOBO RX3000 Station
To add or remove smart sensors from a HOBO RX3000 station:
1. If the station is currently logging, press the Stop button to stop it.
Read tech note
How the RXMOD-A1 with HOBO RX3000 Samples Analog Data and Resolution
How many samples are collected when a measurement is taken and how long is the measurement window open?
Read tech note
Shuttle Firmware_U24 Update Message in HOBOware
If you see the "Shuttle Firmware_U24 Update" message, check your shuttle firmware by selecting Device, Status with the shuttle only connected.
Read tech note
How do I delete, erase, or clear data from my data logger's memory?
When you relaunch a HOBO data logger, the device reverts to the beginning of its memory and starts writing new data over the old.
Read tech note
Electrically Noisy or Incorrect Thermocouple Readings
Electrically noisy or incorrect thermocouple measurements can occur if the USB cable is left connected between the logger and computer during your deployment.
Read tech note
Deploying water temp and water level loggers or developing a QAPP
For users looking for guidance on deploying temperature or water level loggers, or developing a QAPP (Quality Assurance Project Plan), here is a great reference from the EPA:
Read tech note
Why is the RH response time less for the HOBO MX2301 vs the HOBO MX2302?
The RH response time in the HOBO MX2301 internal logger is faster than in the HOBO MX2302 external logger. This is due to the geometry of the location of the internal sensor in the loggers.
Read tech note