Image
Enter your search terms below:
12 results found
How to reconfigure your S-FS-TRMSA-D Module for use with an RX3000 Station
See how to reconfigure your TRMS module for use with an RX3000
Watch how-to video
HOBO RX3000 and the TRMSA-D FlexSmart Module
If you are using both TRMSA-D FlexSmart modules and smart sensors with your HOBO RX3000 station, you are limited to a maximum of three TRMSA-D modules and any combination of smart sensors to reach
Read tech note
Wiring Diagram - Monitoring Differential Air Pressure with an RX3000
Attached is a diagram that shows how to connect and configure a Veris Differential Air Pressure Sensor (T-VER-PX-Series) with an RX3000 Station.
Read tech note
Using the pHionics STs pH Sensor with a HOBO RX3000 Station
This application note describes how to connect, calibrate, and operate the pHionics STs pH sensor with the HOBO RX3000 station.
Read tech note
Wiring Diagram - HOBO RX3000 - RXMOD-A1 Voltage Input Logic Switch
Attached is a wiring diagram that shows how to mo
Read tech note
Adding or Removing Smart Sensors from a HOBO RX3000 Station
To add or remove smart sensors from a HOBO RX3000 station:
1. If the station is currently logging, press the Stop button to stop it.
Read tech note
Wiring Diagram - Monitoring 24VAC On/Off with an RX3000 Station
Attached is a wiring diagram that shows you how to monitor the on/off state of a 24VAC circuit using the RX3000 station.
Read tech note
Wiring Diagram - Monitoring DC Voltage and Current with the RX3000 Station
Attached is a drawing that shows how to monitor DC voltage and/or current using the RX3000 Remote Monitoring Station via the Four Channel Analog Input Module, RXMOD-A1.
Read tech note