Image
Enter your search terms below:
36 results found
How To Add the HOBOnet Manager to a HOBO RX3000 Station
Please click one of the links below for help adding a HOBOnet Manager to a HOBO RX3000 station.
On YouTube
Read tech note
Wiring Diagram - Monitoring 24VAC On/Off with an RX3000 Station
Attached is a wiring diagram that shows you how to monitor the on/off state of a 24VAC circuit using the RX3000 station.
Read tech note
Adding or Removing Smart Sensors from a HOBO RX3000 Station
To add or remove smart sensors from a HOBO RX3000 station:
1. If the station is currently logging, press the Stop button to stop it.
Read tech note
Sample Data - HOBO RX3000 - RXMOD-A1 - Judd Snow Depth Data from HOBOlink
Attached is a screenshot from HOBOlink depicting data recorded by a HOBO RX3000 station that was connected to the Judd Snow-Depth Sensor.
Read tech note
How the RXMOD-A1 with HOBO RX3000 Samples Analog Data and Resolution
How many samples are collected when a measurement is taken and how long is the measurement window open?
Read tech note
Charging a very low HOBO RX3000 or U30 battery
As mentioned in the HOBO RX3000 and U30 documentation, if the battery voltage is allowed to drop too low, it may not be charged within the logger.
Read tech note
Wiring Diagram - Monitoring DC Voltage and Current with the RX3000 Station
Attached is a drawing that shows how to monitor DC voltage and/or current using the RX3000 Remote Monitoring Station via the Four Channel Analog Input Module, RXMOD-A1.
Read tech note
Using the In-Situ® Aqua TROLL® 100/200 Conductivity Sensor with the HOBO® RX3000 Station
This application note describes how to connect and operate the In-Situ Aqua TROLL 100 or 200 (analog output) with the HOBO RX3000 station.
Read tech note