Image
Enter your search terms below:
16 results found
HOBO RX3000 and the TRMSA-D FlexSmart Module
If you are using both TRMSA-D FlexSmart modules and smart sensors with your HOBO RX3000 station, you are limited to a maximum of three TRMSA-D modules and any combination of smart sensors to reach
Read tech note
Wiring Diagram - Monitoring Differential Air Pressure with an RX3000
Attached is a diagram that shows how to connect and configure a Veris Differential Air Pressure Sensor (T-VER-PX-Series) with an RX3000 Station.
Read tech note
Using the pHionics STs pH Sensor with a HOBO RX3000 Station
This application note describes how to connect, calibrate, and operate the pHionics STs pH sensor with the HOBO RX3000 station.
Read tech note
Wiring Diagram - HOBO RX3000 - RXMOD-A1 Voltage Input Logic Switch
Attached is a wiring diagram that shows how to mo
Read tech note
Adding or Removing Smart Sensors from a HOBO RX3000 Station
To add or remove smart sensors from a HOBO RX3000 station:
1. If the station is currently logging, press the Stop button to stop it.
Read tech note
Wiring Diagram - Monitoring 24VAC On/Off with an RX3000 Station
Attached is a wiring diagram that shows you how to monitor the on/off state of a 24VAC circuit using the RX3000 station.
Read tech note
Charging a very low HOBO RX3000 or U30 battery
As mentioned in the HOBO RX3000 and U30 documentation, if the battery voltage is allowed to drop too low, it may not be charged within the logger.
Read tech note