Image
Enter your search terms below:
172 results found
The effects of electroshock fishing on underwater loggers
Although we have not tested this, we have run into incidents in the past where customers have left data loggers in this situation and have not had a problem. On the other hand, we have also had customers whose data loggers stopped recording. It is a gamble and strictly up to you. We do suggest that you pull the data loggers up to be on the safe side, or at least check them after to make sure that they are still recording.
Read tech note
Maximum sensor cable length
The entire network (all sensors combined) cannot exceed 100 meters. As long as your total cable length is below this, it does not matter how you designate the individual cable lengths. It is important to insure that the connections are weatherproof.
Read tech note
Event data logging vs State data logging
A HOBO Event data logger records the opening of the contacts only. It does not record the closing. A HOBO State data logger records changes in the state - both the opening and closing of the switch, (door open/close, light on/off, etc.). Event data will accumulate over time and totalize whereas state data will indicate a high or low position. Some HOBO series support both state and event data logging.
Read tech note
Using Onset data loggers if computer has USB ports and no serial port
Onset offers a Serial-to-USB Adapter (http://www.onsetcomp.com/products/cables/adapt-ser-usb) that provides a simple way to connect HOBO and StowAway® data loggers to available USB ports on your computer.
Onset also offers a USB solution with the U-Series Family of data loggers, which interfaces directly with the USB port on your computer.
Read tech note
Possibility of exposure to chemicals or chemical vapors
This is dependent on the data logger you are using and the chemical and/or concentration of the chemical to which the data logger is exposed. Many chemicals will have an adverse effect on the data loggers and/or the sensors that the loggers utilize. Contact your authorized sales representative with questions regarding specific chemical contact with the data logger that you are using.
Read tech note
Protecting data loggers from electrical discharge (ESD)
A discharge of static electricity may cause a running data logger to stop recording. Precautions should be taken to prevent this while handling the data logger. Discharges may occur when there is a charge difference between the data logger and a cable being connected to it or when a person touches an exposed jack.
Read tech note
Wireline mounting a U20 water level data logger in a well
HOBO Water Level data loggers can be hung in wells using Onset's special low-stretch cable with Teflon coating, to avoid snagging and to make them easy to clean.
Read tech note
Altitude effects on water level data logger range
Onset's HOBO® U20-001-01 Water Level Data Logger is calibrated from 10 to 30 psia. The 10 psia lower limit creates an effective altitude restriction of about 10,000 feet when the data logger is used. The unit can be used above 10,000 feet, but it is outside of the calibrated range, and the accuracy specification does not apply. The data logger will function, but the accuracy will get worse the further below 10 psia the pressure drops.
Read tech note
Using a Water Level Data Logger to Determine Stream Flow
Water level data loggers are commonly used to determine stream flow over time and "peak discharge"
Read tech note
Using 3rd-party barometric pressure data for compensation
HOBOware Pro's Barometric Compensation Assistant now includes the ability to import barometric pressure data from 3rd-party sources such as nearby weather stations. The data needs to be provided in a text data file, and can be in kPa, Pa, mbar, mm HG, psi, or inches Hg. For more information, see the User's Guides for the Barometric Compensation Assistant and the HOBOware Pro software (Importing Data section) or in HOBOware under Help, HOBOware Help.
Read tech note