Enter your search terms below:

Filters

Clear all

Applications

Resource Type

62 results found

Drying a wet circuit board

If possible, remove the board from the case and the battery from the board. Dry the board completely using a hair dryer. If the board was exposed to salt water, rinse the board with fresh water and then dry the board. You may try inserting a new battery and downloading the data. If you are unable to access the data, or see any sign of corrosion or tarnishing on the board, contact the place of purchase for a return number. The data may be retrievable, and the data logger may be repairable. Charges will apply and are dependent on the amount of damage.
Read tech note

A quick temp-accuracy check (ice bath)

We receive many calls requesting information on how to calibrate our data loggers. While our data loggers cannot be calibrated, you can certainly check to see if the data loggers are recording within their specifications. Ideally, testing should be done in a controlled environment. Unfortunately, not everyone has access to this type of environment.
Read tech note