Image
Enter your search terms below:
15 results found
Wiring Diagram - Monitoring a 3-Phase Circuit with the HOBO RX3000 Station and T-VER-E50B2
Attached is a wiring diagram that shows you how to connect the T-VER-E50B2 Power and Energy Meter to the HOBO RX3000 Station.
Read tech note
Wiring Diagram - Monitoring DC Voltage and Current with the H22-001 Energy Logger
Attached is a drawing that shows how to monitor DC voltage and/or current using the H22-001 Energy Logger via the S-FS-CVIA Analog Module.
Read tech note
Wiring Diagram - Monitoring Energy with a UX120-017 and T-VER-E50B2
Attached is a diagram that shows you how to use a T-VER-E50B2 Power and Energy Meter and UX120-017 data logger to monitor energy in a 3-phase circuit.
Warning:
Read tech note
Possibility of exposure to chemicals or chemical vapors
This is dependent on the data logger you are using and the chemical and/or concentration of the chemical to which the data logger is exposed. Many chemicals will have an adverse effect on the data loggers and/or the sensors that the loggers utilize. Contact your authorized sales representative with questions regarding specific chemical contact with the data logger that you are using.
Read tech note
Wiring Diagram - Monitoring Energy Consumption on a Regenerative Drive AC Motor with the Energy Logger
Attached is a drawing that shows how to use the HOBO H22-001 Energy Logger and a Wattnode kWh Transducer to monitor bidirectional energy being used and generated by a regenerative drive AC motor (l
Read tech note
Wiring Diagram - Monitoring a Three-phase Circuit using the HOBO H22-001 Energy Logger and the T-VER-E50B2
Attached is a diagram that shows you how to use the T-VER-E50B2 Power and Energy Meter
Read tech note
Wiring Diagram - Monitoring Motor Run-Time with the UX90-004 Motor On/Off Logger
The UX90-004 includes an internal two-axis AC magnetic field sensor that is designed to pick up the presence of an AC field when the logger is attached to the motor housing.
Read tech note
How often do temperature data loggers need recalibration and/or servicing?
All sensors drift over time and they can be tested in a controlled environment to make sure that they are running within the specifications outlined in the User's Manual. You can use methods such as a simple ice bath or an environmental chamber to verify your device is operating correctly.
Read tech note