Image
Enter your search terms below:
229 results found
Unable to Read Out MX 2001 Logger
After a successful readout on an MX2001 logger that is logging, stopping the logger and then attempting to read out the same data again may fail.
Read tech note
Stream Temperature Monitoring with the HOBO Water Temp Pro (U22-001)
This technical note provides guidelines for using HOBO Water Temp Pro (U22-001) loggers for monitoring steam temperatures.
Read tech note
Remote Water Level Monitoring Application (RX3000)
This technical note provides details on configuring the HOBO RX3000 Remote Monitoring Station with water level sensors with a 4-20mA output.
Read tech note
An alarm was tripped on my MX logger. How do I clear it?
Visual alarms are cleared based on the settings selected under “Maintain Visual Alarms Until” when configuring the logger.
Read tech note
Waterproof shuttle for beginners (Video)
http://www.youtube.com/watch?v=klICZjtoiLE
This 5-minute video will walk you through the steps to take when using a waterproof shuttle.
Read tech note
Stainless steel loggers and salt water
Following is an important application note regarding the deployment of the following products:
U20-001-01 – HOBO Water Level Logger
U12-015 – HOBO U12 Stainless Steel Temp Logger
U12-015-02 – HOBO U12 Stainless Steel Temp Logger with 5” probe
Read tech note
Data logger is shutting off prematurely
A discharge of static electricity may cause a running data logger to stop recording. Precautions should be taken to prevent this while handling the data logger.
Discharges may occur when there is a charge difference between the data logger and a cable being connected to it or when a person touches an exposed jack.
Read tech note
Waterproof shuttle firmware update
Follow this link to a helpful video if you need to update your waterproof shuttle firmware.
http://www.youtube.com/watch?v=8_O9-x7CPt8
Read tech note
Waterproof shuttle for beginners
These photos illustrate how to use the Waterproof Shuttle and a data logger together. We are showing a U22-001 logger for this demonstration, but the same steps apply to any USB-based optic logger. These steps are necessary for initial deployment of a logger and when communicating with the logger directly.
Read tech note