18 results found.
Stopping your data logger
All HOBO and StowAway data loggers shut off when the memory is full (unless wrap-around is selected) or the data is downloaded to a computer. Once the data is downloaded to the computer, the data logger is in off mode and will need to be relaunched to continue data collection. If the data logger you are using is shuttle-compatible and you are downloading to a shuttle, the shuttle will automatically relaunch the data logger using the previous settings.
Read tech note
A quick temp-accuracy check (ice bath)
We receive many calls requesting information on how to calibrate our data loggers. While our data loggers cannot be calibrated, you can certainly check to see if the data loggers are recording within their specifications. Ideally, testing should be done in a controlled environment. Unfortunately, not everyone has access to this type of environment.
Read tech note
Protecting data loggers from electrical discharge (ESD)
A discharge of static electricity may cause a running data logger to stop recording. Precautions should be taken to prevent this while handling the data logger. Discharges may occur when there is a charge difference between the data logger and a cable being connected to it or when a person touches an exposed jack.
Read tech note
Drying a wet circuit board
If possible, remove the board from the case and the battery from the board. Dry the board completely using a hair dryer. If the board was exposed to salt water, rinse the board with fresh water and then dry the board. You may try inserting a new battery and downloading the data. If you are unable to access the data, or see any sign of corrosion or tarnishing on the board, contact the place of purchase for a return number. The data may be retrievable, and the data logger may be repairable. Charges will apply and are dependent on the amount of damage.
Read tech note
Possibility of exposure to chemicals or chemical vapors
This is dependent on the data logger you are using and the chemical and/or concentration of the chemical to which the data logger is exposed. Many chemicals will have an adverse effect on the data loggers and/or the sensors that the loggers utilize. Contact your authorized sales representative with questions regarding specific chemical contact with the data logger that you are using.
Read tech note
Using Onset data loggers if computer has USB ports and no serial port
Onset offers a Serial-to-USB Adapter (http://www.onsetcomp.com/products/cables/adapt-ser-usb) that provides a simple way to connect HOBO and StowAway® data loggers to available USB ports on your computer.
Onset also offers a USB solution with the U-Series Family of data loggers, which interfaces directly with the USB port on your computer.
Read tech note
Logger power failure and data loss
The data is stored on non-volatile EEPROM. For data loggers with external batteries: change batteries and offload data, then relaunch normally. For data loggers with internal batteries: as long as the EEPROM has not been damaged, the data can be retrieved by Onset. Please contact the place of purchase for a return authorization number and request data back service.
Read tech note
How often do temperature data loggers need recalibration and/or servicing?
All sensors drift over time and they can be tested in a controlled environment to make sure that they are running within the specifications outlined in the User's Manual. You can use methods such as a simple ice bath or an environmental chamber to verify your device is operating correctly.
Read tech note