A discharge of static electricity may cause a running data logger to stop recording. Precautions should be taken to prevent this while handling the data logger. Discharges may occur when there is a charge difference between the data logger and a cable being connected to it or when a person touches an exposed jack.

If possible, remove the board from the case and the battery from the board. Dry the board completely using a hair dryer. If the board was exposed to salt water, rinse the board with fresh water and then dry the board. You may try inserting a new battery and downloading the data. If you are unable to access the data, or see any sign of corrosion or tarnishing on the board, contact the place of purchase for a return number. The data may be retrievable, and the data logger may be repairable. Charges will apply and are dependent on the amount of damage.

The data is stored on non-volatile EEPROM. For data loggers with external batteries: change batteries and offload data, then relaunch normally. For data loggers with internal batteries: as long as the EEPROM has not been damaged, the data can be retrieved by Onset. Please contact the place of purchase for a return authorization number and request data back service.

A thermocouple is a kind of battery made by joining two dissimilar metals together where a small voltage is generated by the difference between teh metals. The voltage gnerated changes with temperature. To make a thermocouple temperature sensor out of thermocouple extenision wire, strip the insulation back a little and make an electrical connection between the two wires. The more reliable your connection, the more reliable the thermocouple. Welding is the best way to form a reliable thermocouple. A resistance welding machine (spot welder) can be used (with practice), and TIG welding works nicely too.