Image
Enter your search terms below:
40 results found
Wiring Diagram - Monitoring DC Voltage and Current with the RX3000 Station
Attached is a drawing that shows how to monitor DC voltage and/or current using the RX3000 Remote Monitoring Station via the Four Channel Analog Input Module, RXMOD-A1.
Read tech note
Using the Judd Communications Snow Depth Sensor with the HOBO RX3000 Station
Check out the attached PDF to learn how to use the Judd Communications Snow-D
Read tech note
Measure Direct Current with the HOBO RX3000 and the T-VER-H971 Transducer
To measure Direct Current using the HOBO RX3000 and the T-VER-H971 transducer, see attachment.
Read tech note
Using the Gill Instruments WindSonic Opt 3 Wind Speed and Direction Sensor with the HOBO® RX3000 Station
This application note describes how to connect and operate the Gill WindSonic sensor (Opt 3 with analog outputs) with the HOBO RX3000 station.
Read tech note
Wiring Diagram - Monitoring Three-phase Energy using the RX3000 Station and a Wattnode kWh Transducer
Attached is a wiring diagram that shows how to connect a Wattnode kWh Transducer to a H
Read tech note
Wiring Diagram - Monitoring a 3-Phase Circuit with the HOBO RX3000 Station and T-VER-E50B2
Attached is a wiring diagram that shows you how to connect the T-VER-E50B2 Power and Energy Meter to the HOBO RX3000 Station.
Read tech note
Remote Water Level Monitoring Application (RX3000)
This technical note provides details on configuring the HOBO RX3000 Remote Monitoring Station with water level sensors with a 4-20mA output.
Read tech note
Working with the HOBOlink web-enabled software platform
This course teaches you all about HOBOlink's web-enabled software platform used with HOBO data loggers and sensors, and how it works with the RX3000 station. (Runtime: Approximately 50min)
Watch training