Image
Enter your search terms below:
1221 results found
An alarm was tripped on my MX logger. How do I clear it?
Visual alarms are cleared based on the settings selected under “Maintain Visual Alarms Until” when configuring the logger.
Read tech note
Locking MX logger so that no one else can configure it
Connect to the logger and tap Logger Password. Enter a password up to 10 characters. The password will then be required any time another mobile device attempts to connect to the logger.
Read tech note
Checking MX logger remaining battery power and logger status with HOBOmobile instead of checking the logger LCD
If your device is within range of the logger, you can view the logging status in the Recently Seen/In Range List on the HOBOs screen.
Read tech note
Lost connection while setting up MX logger. Will it still start?
If you did not tap Start before the connection was lost, then the logger will not start logging. Connect to the logger again, finish choosing your settings, and then tap Start.
Read tech note
MX logger is listed in the wrong group. How can I change that?
- Connect to the logger, tap Configure, and then tap Group.
- Select a group for the logger or create a new group.
- If you do not want the logger to be listed in any group, th
Read tech note
I can't connect to MX logger in the Recently Seen/In Range list
- Close HOBOmobile and then reopen it.
- Power cycle the mobile device and try connecting again.
Read tech note
MX logger not appearing in the Recently Seen/In Range list on the HOBO screen
- The logger may need new batteries.
Read tech note