Enter your search terms below:

Filters

Clear all

Applications

Topic

39 results found

Wiring Diagram - Monitoring Three-phase Energy using the ZW Wireless Data Node and the Wattnode kWh Transducer

Attached is a wiring diagram that shows how to connect a Wattnode kWh Transducer to a HOBO ZW-008 or ZW-005 wireless data node to log energy consumption on a 3-phase circuit.

Read tech note

Wiring Diagram - Monitoring Motor Run-Time with the UX90-004 Motor On/Off Logger

The UX90-004 includes an internal two-axis AC magnetic field sensor that is designed to pick up the presence of an AC field when the logger is attached to the motor housing.

Read tech note

Wiring Diagram - Monitoring Single Phase Energy using the UX90-001 and the Wattnode kWh Transducer

Attached is a drawing that shows you how to use a UX90-001 State Data Logger and a T-WNB-3D-240 3-phase kWh Transducer to monitor energy consumption on a single-phase circuit.(This transducer can b

Read tech note

Wiring Diagram - Monitoring Energy with a UX120-017 and T-VER-E50B2

Attached is a diagram that shows you how to use a T-VER-E50B2 Power and Energy Meter and UX120-017 data logger to monitor energy in a 3-phase circuit.

Warning:

Read tech note

Wiring Diagram - Monitoring AC Current and Voltage on a Residential Panel - UX120-006M

Attached is a drawing that shows how to use the UX120-006M data logger to monitor 240 VAC voltage via the Conlab T-CON-ACT-300 voltage transducer.

Read tech note

Wiring Diagram - Monitoring DC Voltage and Current with the H22-001 Energy Logger

Attached is a drawing that shows how to monitor DC voltage and/or current using the H22-001 Energy Logger via the S-FS-CVIA Analog Module.

Read tech note

Wiring Diagram - Measuring Compressed Air Flow with a stand alone analog logger

Attached is a drawing that shows you how to connect a UX120-006M logger to the compressed air flow meter from CDI, p/n T-CDI-5400-20S or the T-CDI-5200-10S via the CABLE-4-20MA adapter cable.

Read tech note

Wiring Diagram - Monitoring Differential Air Pressure with a UX120-006M or ZW

Attached is a diagram that shows how to connect a Veris Differential Air Pressure Sensor (T-VER-PX-Series) with a UX120-006M logger, or a ZW-006 or ZW-008 data node.

Read tech note

An alarm was tripped on my MX logger. How do I clear it?

Visual alarms are cleared based on the settings selected under “Maintain Visual Alarms Until” when configuring the logger.

Read tech note

MX logger is listed in the wrong group. How can I change that?

  • Connect to the logger, tap Configure, and then tap Group.
  • Select a group for the logger or create a new group.
  • If you do not want the logger to be listed in any group, th
Read tech note