Image
Enter your search terms below:
40 results found
Wiring Diagram - Monitoring 24VAC On/Off with an RX3000 Station
Attached is a wiring diagram that shows you how to monitor the on/off state of a 24VAC circuit using the RX3000 station.
Read tech note
Wiring Diagram - Monitoring Differential Air Pressure with an RX3000
Attached is a diagram that shows how to connect and configure a Veris Differential Air Pressure Sensor (T-VER-PX-Series) with an RX3000 Station.
Read tech note
Calibrating ECH2O Soil Moisture Sensors Application Note
Onset adds smart sensor adapters to the ECH2O probes so that they are plug‐and‐play compatible with HOBO® U30 stations and HOBO Micro Stations.
Read tech note
Soil Monitoring Station with the HOBO Micro Station (H21-002)
This technical note provides a solution for monitoring soil temperature and moisture with the HOBO Micro Station (H21-002).
Read tech note
Using the pHionics STs pH Sensor with a HOBO RX3000 Station
This application note describes how to connect, calibrate, and operate the pHionics STs pH sensor with the HOBO RX3000 station.
Read tech note
Judd Communications Snow Depth Sensor with the U30 Remote Monitoring Station
Check out the attached PDF to find out how to use the Judd Communications Snow-Depth Sensor with the HOBO® U30 Station.
Read tech note
Installing Onset soil moisture sensors
Use the attached guide as a reference when deploying soil moisture Smart Sensors.
Read tech note
Verifying RH accuracy on HOBO data loggers
Testing the accuracy of relative humidity sensors requires carefully-controlled conditions and a considerable amount of time. Please see the white paper Testing the Accuracy of Sensirion Relative Humidity Sensors in HOBO Data Loggers for complete details on the recommended procedure to follow.
Read tech note
Smart sensor cable fix
Problem: My smart sensor data shows a -888.888 for a good portion of the data file.
Note: -888.888 means that the logger could not find the smart sensor after the logger was launched successfully.
Read tech note
U30 and excitation wiring with S-VIA-CM14 modules
Here is a wiring diagram for use with external sensors and the S-VIA-CM14s. Remember the excitation current required to power the external sensors cannot exceed 50 milliamps total.
http://www.onsetcomp.com/files/U30%20VIA%20and%20S_VIA_CM14.JPG
Read tech note