Image
19 results found.
Introduction to the HOBO RX3000 Remote Monitoring System
Get an in-depth understanding of the new web-based HOBO RX3000 Remote Monitoring System for measuring weather conditions outdoors, and energy, power, and environmental conditions indoors.
Watch Webinar
Using the Gill Instruments WindSonic Opt 3 Wind Speed and Direction Sensor with the HOBO® RX3000 Station
This application note describes how to connect and operate the Gill WindSonic sensor (Opt 3 with analog outputs) with the HOBO RX3000 station.
Read tech note
Using the In-Situ® Aqua TROLL® 100/200 Conductivity Sensor with the HOBO® RX3000 Station
This application note describes how to connect and operate the In-Situ Aqua TROLL 100 or 200 (analog output) with the HOBO RX3000 station.
Read tech note
Connecting a Thermocouple to an RX3000 Station
In order to connect a thermocouple to an RX3000 station, you will need to use a third-party thermocouple transmitter, like the Omega TX13 series, which is available directly from Omega,
Read tech note
Wiring Diagram - Monitoring Differential Air Pressure with an RX3000
Attached is a diagram that shows how to connect and configure a Veris Differential Air Pressure Sensor (T-VER-PX-Series) with an RX3000 Station.
Read tech note
Wiring Diagram - Monitoring 24VAC On/Off with an RX3000 Station
Attached is a wiring diagram that shows you how to monitor the on/off state of a 24VAC circuit using the RX3000 station.
Read tech note
Wiring Diagram - Monitoring DC Voltage and Current with the RX3000 Station
Attached is a drawing that shows how to monitor DC voltage and/or current using the RX3000 Remote Monitoring Station via the Four Channel Analog Input Module, RXMOD-A1.
Read tech note