Attached is a wiring diagram that shows how to connect a Wattnode kWh Transducer to a HOBO RX3000 Station to log energy consumption in a 3-phase circuit.

Note: The wiring from the RX3000 to the Wattnode would be the same for 2-phase (or split-phase) and single-phase circuits.

Warning:

Installing transducers in an energized electrical enclosure or on any energized conductor can result in severe injury or death. These transducers are for installation by qualified personnel only. To avoid electrical shock, do not perform any installation or servicing of these transducers unless you are qualified to do so. Disconnect and lock-out all power sources during installation and servicing. Please read transducer user manuals for instructions and use.

Helpful Links:

RX3000 Station

Wattnode kWh Transducer (480 VAC version in this example)

Pulse Input Adapter

Categories

Tech Note
Getting Started