Attached is a wiring diagram that shows you how to connect the T-VER-E50B2 Power and Energy Meter to the HOBO RX3000 Station.

Note: The T-VER-E50B2 ouputs pulses representing Watt/hours, Amp/hours, and VAR/hours that are logged by the RX3000 station and displayed on the HOBOlink web site.

We offer a spreadsheet on the T-VER-E50B2 web page under Documentation that allows you the ability to manually calculate other parameters from these three sets of pulses, including total amperage (1 value), average voltage (1 value), average power factor (1), and average power in kW (1) value.

Warning: Installing transducers in an energized electrical enclosure or on any energized conductor can result in severe injury or death. These transducers are for installation by qualified personnel only. To avoid electrical shock, do not perform any installation or servicing of these transducers unless you are qualified to do so. Disconnect and lock-out all power sources during installation and servicing. Please read transducer user manuals for instructions and use.

Products include:

T-VER-E50B2 Power and Energy Meter

RX3000 Station

T-ACT-0750-50 Current Transformers (50A CTs shown for example)

S-UCC-M006 Pulse Input Adapters (3 required)

Categories

Tech Note
Getting Started
Troubleshooting & Maintenance