u30 data logger

can we configure the data logger with hoboware software without connect any sensor or smar sensor or should connect at least one sensor to configure ?

Comments & Subscriptions


 

Hi Mohamed. If you are using the station loggers, like the H21 or H22, then you must plug the sensors in during the configuration. They can be removed for a short while after that if you are using a delayed start but be sure to plug them back in before the logger starts recording data. Otherwise you will see -888's in the data set.

Comment or Subscribe


 
Comment on this
Credentials (your e-mail address will not be shown publicly)
This screen name is what will publicly represent you as a user.
This email address will not appear to the public. The username field will be used to identify you as a poster..
Image CAPTCHA
Enter the characters shown in the image.
Subscribe to comments