Parts & Accessories - Accessories

    PILOT-RODx

     

    The pilot rod is used with a slide hammer (SLIDE-HAMMER) for quick and easy deployment of HOBOnet Multi-Depth Soil Moisture Sensors (RXW-GPX-XXX). By creating a hole with the same profile and size of the soil moisture sensor being deployed, this tool eliminates the need to excavate and backfill holes. The pilot rod threads onto the slide hammer, which drives the rod into the soil, creating the required profile. After removing the rod, the soil moisture sensor can be pushed into the soil easily. Once the sensor is deployed, the soil will relax around it, filling in any gaps and establishing the contact needed for accurate soil moisture measurements.

    Onset offers two pilot rod options: the PILOT-ROD4 (28”) for use with three- and four-segment HOBOnet Multi-Depth Soil Moisture Sensors (RXW-GP3 and RXW-GP4), and the PILOT-ROD6 (40”) for use with six-segment HOBOnet Multi-Depth Soil Moisture Sensors (RXW-GP6).

    Add to Cart
    Compare Product

    Compare
    SLIDE-HAMMER

    The slide hammer is used with a pilot rod (PILOT-RODx) for quick and easy deployment of HOBOnet Multi-Depth Soil Moisture Sensors (RXW-GPX-XXX). The slide hammer forces the pilot rod into the soil to create the profile needed for the soil moisture sensor. 

    Add to Cart
    Compare Product

    Compare
    TEROS-CLIP

    The Verification Clip verifies the proper function and accuracy of HOBOnet T11 and HOBOnet T12 soil moisture sensors. 

    Add to Cart
    Compare Product

    Compare
    BOOT-MX2201-2202

    These optional flexible boots provide a reliable way to mount the HOBO Pendant MX2201 and MX2202 loggers to non-flat surfaces such as rebar or posts.

    Add to Cart
    Compare Product

    Compare
    RXMOD-W1

    ​The RX3000 Water Level Sensor Module (RXMOD-W1) offers users the ability to monitor water level, pressure, and temperature, as well as barometric pressure, with the HOBO RX3000 Remote Monitoring Station.  It is configured through HOBOlink, Onset’s cloud-based software. For water level applications, a HOBO RX3000 station, water level sensor cable (CABLE-RWLMOD-XXX), and water level sensor (MX2001-0X-S or MX2001-0X-Ti-S) are required.

    Add to Cart
    Compare Product

    Compare
    WELL-CAP-02

    This locking well cap provides a convenient way to suspend HOBO MicroRX Water Level sensor cables in a well, and provides strain relief (especially important for long cables).

    Add to Cart
    Compare Product

    Compare
    T-SDX-93030-500

    Hydrophobic Vent Tube Caps attach to the opening of the Stevens SDX Pressure Sensor vent tube. The caps have a hydrophobic membrane that allows barometric pressure compensation without allowing water ingress, while also not requiring replacement. Unlike desiccant cartridges, this cap does not “pull” moisture out of the tube. If there is moisture in the tube already, it will remain there with the use of this cap. It is recommended that each SDX vent tube is protected from water ingress with either this cap or a desiccant cartridge (T-SDX-93030-010).

    Add to Cart
    Compare Product

    Compare
    2P-CT-EG4100-KIT

    Sensor port connector with 2 positions. Accepts one positive and one negative wire. Used to connect AC current transformers to one input position on an EG4100 device. Replacement component for EG4100 meters.

    Add to Cart
    Compare Product

    Compare
Page 1 / 4