Accessories

All Products

HOBO data loggers for monitoring indoor, outdoor, and underwater environments.



Download the Catalog!
    BOOT-MX2204-xx

    The optional MX2204 thermoplastic elastomer (Santoprene) boot provides cushioning for use in harsh conditions — offered in black to minimize underwater visibility, in white to minimize solar radiation absorption or grey. Five boots included.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    T-SDX-93030-010

    The SDX is a “Wet-Wet” device. While it is important to keep the SDX cable’s vent tube unobstructed for barometric pressure compensation, neither the pressure transducer nor internal electronics are damaged by condensation or moisture entering the vent tube. For best results, we recommend the desiccant cartridge with vent tube adapter.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    WELL-CAP-01

    This locking well cap provides convenient mounting for HOBO loggers in wells. Used with the HOBO MX2001 it supports the logger at the top of the well for optimal wireless transmission range.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    RXMOD-R1

    The optional Relay Module allows for up to three individual relays to be activated or pulsed in response to alarms.  Each relay contact closure can be configured as normally open or normally closed through HOBOlink. A HOBO RX3000 is required for this product.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    RXMOD-A1

    The optional analog module has four analog inputs that support excitation power, scaling, and statistics measurements.  These four, single-ended sensor inputs are configured through HOBOlink. A HOBO RX3000 is required for this product.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    CABLE-RX-PWR

    The external DC power cable (CABLE-RX-PWR) is used to connect a user-supplied power source to the HOBO RX3000 Monitoring Station to charge the station’s internal battery. The external power source can be an intermittent power source, such as a 6W or larger solar panel. The external power source must be able to supply 6W, but the average power used will be much less and depends on the number and type of sensors, logging interval, and the frequency of internet connections.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    U26-CAL-SOL

    Sodium Sulfite solution (500 mL) is used for calibrating the HOBO Dissolved Oxygen Logger at 0% saturation, which is optional.

    • Concentration: 5% w/v
    Add to Cart
    Add to Quote
    Compare Product

    Compare
    U26-GUARD-2

    The Anti-fouling Protective Guard can be used in place of the standard protective guard for protection against fouling during deployment. The anti-fouling guard uses copper windings to reduce bio-fouling, while still allowing good water flow to the sensor.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
Page 2 / 3