All Products

All Products

HOBO data loggers for monitoring indoor, outdoor, and underwater environments.



Download the Catalog!
    RXMOD-W1

    ​The RX3000 Water Level Sensor Module (RXMOD-W1) offers users the ability to monitor water level, pressure, and temperature, as well as barometric pressure, with the HOBO RX3000 Remote Monitoring Station.  It is configured through HOBOlink, Onset’s cloud-based software. For water level applications, a HOBO RX3000 station, water level sensor cable (CABLE-RWLMOD-XXX), and water level sensor (MX2001-0X-S or MX2001-0X-Ti-S) are required.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    WELL-CAP-02

    This locking well cap provides a convenient way to suspend HOBO MicroRX Water Level sensor cables in a well, and provides strain relief (especially important for long cables).

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    T-SDX-93030-500

    Hydrophobic Vent Tube Caps attach to the opening of the Stevens SDX Pressure Sensor vent tube. The caps have a hydrophobic membrane that allows barometric pressure compensation without allowing water ingress, while also not requiring replacement. Unlike desiccant cartridges, this cap does not “pull” moisture out of the tube. If there is moisture in the tube already, it will remain there with the use of this cap. It is recommended that each SDX vent tube is protected from water ingress with either this cap or a desiccant cartridge (T-SDX-93030-010).

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    2P-CT-EG4100-KIT

    Sensor port connector with 2 positions. Accepts one positive and one negative wire. Used to connect AC current transformers to one input position on an EG4100 device. Replacement component for EG4100 meters.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    MX2500-MAINT-KIT

    The Maintenance Kit includes the Calibration Kit (MX2500-CAL-KIT) and the Electrode Storage Solution (MX2500-STORE-SOLN).

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    MX2500-STORE-SOLN

    The Electrode Storage Solution is used to properly store and condition the pH electrode that is used with the HOBO MX pH Logger. The purpose of the storage solution is to maintain the hydrated gel layer that is integral to accurate pH readings.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    MX2500-CAL-xx

    The pH 4.01, 7.00, and 10.00 Calibration Solutions (475 mL bottles) are used to calibrate the pH electrode in the HOBO MX pH Logger.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    MX2500-CAL-KIT

    The Calibration Kit includes pH 4.01, pH 7.00, pH 10.00 buffer solutions (475 mL bottles), and the 4 oz. calibration beaker (MX2500-CAL-BKR).

    Add to Cart
    Add to Quote
    Compare Product

    Compare
Page 1 / 4