All Products

All Products

    RXMOD-W1

    ​The RX3000 Water Level Sensor Module (RXMOD-W1) offers users the ability to monitor water level, pressure, and temperature, as well as barometric pressure, with the HOBO RX3000 Remote Monitoring Station.  It is configured through HOBOlink, Onset’s cloud-based software. For water level applications, a HOBO RX3000 station, water level sensor cable (CABLE-RWLMOD-XXX), and water level sensor (MX2001-0X-S or MX2001-0X-Ti-S) are required.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    WELL-CAP-02

    This locking well cap provides a convenient way to suspend HOBO MicroRX Water Level sensor cables in a well, and provides strain relief (especially important for long cables).

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    WELL-CAP-01

    This locking well cap provides convenient mounting for HOBO loggers in wells. Used with the HOBO MX2001 it supports the logger at the top of the well for optimal wireless transmission range.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    RXMOD-R1

    The optional Relay Module allows for up to three individual relays to be activated or pulsed in response to alarms.  Each relay contact closure can be configured as normally open or normally closed through HOBOlink. A HOBO RX3000 is required for this product.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    RXMOD-A1

    The optional analog module has four analog inputs that support excitation power, scaling, and statistics measurements.  These four, single-ended sensor inputs are configured through HOBOlink. A HOBO RX3000 is required for this product.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    U26-CAL-SOL

    Sodium Sulfite solution (500 mL) is used for calibrating the HOBO Dissolved Oxygen Logger at 0% saturation, which is optional.

    • Concentration: 5% w/v
    Add to Cart
    Add to Quote
    Compare Product

    Compare
    U26-GUARD-2

    The Anti-fouling Protective Guard can be used in place of the standard protective guard for protection against fouling during deployment. The anti-fouling guard uses copper windings to reduce bio-fouling, while still allowing good water flow to the sensor.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    M-CDY

    This accessory provides a convenient place to organize and mount excess sensor cable.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
Page 1 / 2