These photos illustrate how to use the Waterproof Shuttle and a data logger together. We are showing a Water Temp Pro v2 - U22-001 logger for this demonstration, but the same steps apply to any USB-based optic logger. These steps are necessary for initial deployment of a logger and when communicating with the logger directly.

Image

Note that Water Temp Pro coupler is attached to the shuttle.

Image

Insert the data logger tightly into the coupler. You may need to tap the logger down with the palm of your hand to insure a proper connection.

Image

Insert the USB cable into the shuttle. Make sure the USB cable is also plugged into the computer with Hoboware Pro installed.

Image

Squeeze the lever on the side of the coupler so that the end of the lever makes contact with the shuttle. (No, it will not break.)

Image

The "OK" LED light should glow and stay on. At this point you will be able to communicate with your logger directly through the shuttle. Referrer to the Hoboware Users Guide for launching help.

HAPPY LOGGING!

Categories

Tech Note
Getting Started