Attached is a drawing that illustrates how to use a HOBO UX90-001 State Data Logger and a T-WNB-3D-480 3-phase kWh Transducer to monitor energy consumption on a three-phase circuit.

(Note: This transducer can be used on single-, split-, or 3-phase circuits.)

Warning:

Installing transducers in an energized electrical enclosure or on any energized conductor can result in severe injury or death. These transducers are for installation by qualified personnel only. To avoid electrical shock, do not perform any installation or servicing of these transducers unless you are qualified to do so. Disconnect and lock-out all power sources during installation and servicing. Please read transducer user manuals for instructions and use.

Helpful links:

UX90-001 State Data Logger

T-VER-WNB-3D-480

Categories

Tech Note
Getting Started