Veris Kilowatt Hour Transducer 3-Phase, 800 Amp Sensor

Part # T-VER-8053-800
 
 
$849


Overview

The Veris AC Kilowatt Transducer incorporates three split-core AC current sensors and three voltage leads and outputs a signal proportional to kilowatts of power (demand). Accepting an input primary voltage of 480 Volts AC rms, this transducer requires a Pulse Input Adapter. Because these sensors tie directly into the line, they should be used only by qualified personnel. NOTE: Not recommended for use with variable frequency drives.

Highlighted Features

  • Split-core installation eliminates the need to remove conductors
  • Self-contained 0 to 800 AMP current transducer for large 3-phase AC loads
  • Accurate electronic pulse output

In what environment does this sensor operate?

This sensor operates in an indoor environment.

What measurements does this sensor support?

The T-VER-8053-800 sensor supports the following measurement: Kilowatt Hours (kWh)

The Veris AC Kilowatt Transducer incorporates three split-core AC current sensors and three voltage leads and outputs a signal proportional to kilowatts of power (demand). Accepting an input primary voltage of 480 Volts AC rms, this transducer requires a Pulse Input Adapter. Because these sensors tie directly into the line, they should be used only by qualified personnel. NOTE: Not recommended for use with variable frequency drives.

Highlighted Features

  • Split-core installation eliminates the need to remove conductors
  • Self-contained 0 to 800 AMP current transducer for large 3-phase AC loads
  • Accurate electronic pulse output

In what environment does this sensor operate?

This sensor operates in an indoor environment.

What measurements does this sensor support?

The T-VER-8053-800 sensor supports the following measurement: Kilowatt Hours (kWh)

To see the full specifications for this product, please see our product manual found under the documentation tab if available.

Frequency: 50 to 60Hz
Accuracy: ±1% (3-phase model conforms to ANSI C12.1 metering standards)
CT range: 0-300 Amp (T-VER-8051-300); 0-800 Amp (T-VER-8053-800)
Circuit connection: 3- or 4-wire
Maximum output current: 100mA at 24VAC/DC
Operating temp range: 0° to 60°C (32° to 140°F)
Operating humidity range: 0-95% RH (non-condensing)
Output signal to HOBO Energy Logger: Pulse (Normally open Opto-FET)
Pulse width: 200 msec
 
Opening dimensions of each CT
T-VER-8051-300: 3.8 x 3.2 cm (1.5 x 1.25”)
T-VER-8053-800: 7.3 x 6.2 cm (2.9 x 2.5”)
 
Number of data channels: 1

To download the manual from Veris click here.

The following are associated resources for this product. In general users of this product can gain insight into its possible use by utilizing the resources below.

Upcoming Webinars & Courses
On-demand Webinars & Videos