Sensors

All Products

    T-VER-E50B2

    Build better energy efficiency and power management with the E50B2 Power & Energy Meter. This cost-effective sensor is simple to deploy and can either be installed on standard DIN rail or be surface mounted. The E50B2 integrates with HOBO UX, U30, ZW, H22, and H21 data loggers.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    S-FS-TRMSA-D

    The 15-bit two-channel FlexSmart True RMS Current / Voltage Module accepts an input range of 5mV to 512mV and is compatible with 333mV FS output sensors. Field wiring is 2-wire via screw terminals.

    NOTE: If using the S‐FS‐TRMSA‐D with a U30‐GSM or RX3003-00-01, the S‐FS‐TRMSA‐D should be located approximately 1 meter (3 ft) from the U30 in order to avoid interference from the U30's GSM radio. Use Smart Sensor extension cable Onset part # S‐EXT‐M002.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    T-CON-ACT-300

    0-300 volt self-powered transformer for monitoring sine wave, single-phase AC voltage. Requires Input Cable for use with U12 loggers.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    T-CON-ACT-150

    0-150 volt self-powered transformer for monitoring sine wave, single-phase AC voltage. Requires Input Cable for use with U12 loggers.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    T-MAG-SPT-150

    The Magnelab 150-Volt AC Potential Transformer is used with the FlexSmart TRMS Module to provide accurate measurement of AC voltage. One or two PTs can be used with each FlexSmart TRMS module. This sensor offers an accuracy of ±1% (from 10% to 130% of rated voltage), but because this transformers ties directly into the line, it should be used only by qualified personnel.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    T-MAG-SPT-300

    The Magnelab 300-Volt AC Potential Transformer is used with the FlexSmart TRMS Module to provide accurate measurement of AC voltage. One or two PTs can be used with each FlexSmart TRMS module. This sensor offers an accuracy of ±1% (from 10% to 130% of rated voltage), but because this transformers ties directly into the line, it should be used only by qualified personnel.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    T-MAG-SPT-600

    The Magnelab 600-Volt AC Potential Transformer is used with the FlexSmart TRMS Module to provide accurate measurement of AC voltage. One or two PTs can be used with each FlexSmart TRMS module. This sensor offers an accuracy of ±1% (from 10% to 130% of rated voltage), but because this transformers ties directly into the line, it should be used only by qualified personnel.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
    S-FS-TRMSA

    The 15-bit two-channel FlexSmart True RMS Current / Voltage Module accepts an input range of 5mV to 512mV and is compatible with 333mV FS output sensors. Field wiring is 2-wire via screw terminals.

    Add to Cart
    Add to Quote
    Compare Product

    Compare
Page 1 / 2